Versions Compared

Old Version 5

changes.mady.by.user VIZpin Customer Care

Saved on

compared with

New Version Current

changes.mady.by.user VIZpin Customer Care

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Previous

Home

Next

Entegrity Smart Door/Gate Controllers can be configured for a normally closed relay. This means that in most installations that require the normally closed function, like when using a mag-lock an external rely relay will not be required to properly control the locking device.

To change the relay mode the VIZpin controller:

** First login to your partner portal at VIZpin.net

Click the Smart Device button and then edit for the appropriate Smart Device- it must show 1

.

18 in the firmware column or the normally closed option will not be available

  • From the relay mode drop down menu- select the option for mag-lock normally closed and click apply

    • Use VIZpin link to apply these updated settings to the Smart Device controller by refreshing your VIZpin SMART app and triggering the unit

  • It will reset and display a pulsing red LED

  • Trigger the VIZpin controller to confirm the relay mode has been updated for normally closed

    • Iframe
    scrollingno
    srchttps://www.youtube.com/embed/YiDkLxq0fPAvEnFGHJlEVs?si=Q7fUyBQkYCSrC1xj
    width100%
    frameborderhide
    height250px
    To change the relay mode the VIZpin controller:

    1. First login to your partner portal at VIZpin.net

    2. Click the Smart Device button and then edit for the appropriate Smart Device- it must show 1.18 in the firmware column or the normally closed option will not be available

    3. From the relay mode drop down menu- select the option for mag-lock normally closed and click apply.

    4. Use VIZpin link to apply Apply these updated settings to the Smart Device controller Controller by refreshing your VIZpin SMART Smart app and triggering unlocking the unit device.

    5. It will reset and display a pulsing red LED.

    6. Trigger the VIZpin controller to confirm the relay mode has been updated for normally closed.

    Image Added
    Image Added
    Image Added

    NOTE: Only the controller's RED, BLACK, BLUE and YELLOW wires will be used for this type of installation

    1. Cut the leads from the controller's unused wires and cover the ends with electrical tape or heat-shrink tubing

    2. Connect the controller's RED and BLUE wires to the power supply positive 12VDC (+)

    3. Connect the controller's YELLOW wire to the maglock's positive (+)1

    4. Connect the controller's BLACK wire (-) and the maglock's negative (-) to the power supply GND (-)

    5. Turn on the power supply – the controller displays a pulsing red LED within a few seconds and the maglock engages

    1Use a pigtail connector if supplied with the maglock

    *VP1 must be mounted on the secure side of the door/gate

    **Min. 22 AWG wiring where applicable